Cat. no.: UP028000
CHARACTERISTICS
● Push button and status indication
● Push button for operate dimmer manual
● Control switch state of the lamp
● Relative dimming function
● Control brightness values of the lamp
● State report, error report
● 16 scenes setting
● Status response
● Selection of preferred state after bus voltage failure and recovery
● Preset function, set preset function

• Output, load terminal
• KNX/EIB bus connection
• No using, reserved
• Push button
• Programming button and LED,red LED for assigning the physical address,
  green LED for device running normally
• Manual operation button and LED
• For screw to fix device

• Power Supply: 21~30V DC, via the EIB bus
• Current consumption <24mA
• Power consumption: Max.720mW
• Un rated voltage: 230V AC (50/60 HZ)
• In rated current: 1A
• Max. leakage loss: 5W
• Red LED and push button: For assigning the physical address
• Green LED flashing: For display device running normally
• Push button and LED: For operation and status indication
• Push button and LED: For operate dimmer and status indication
• EIB/KNX: Bus connection terminal (black/red)
• Terminal: For load
• Temperature Operation -5°C ~45°C
• Storage -25°C ~55°C
• Transport -25°C ~70°C